Onwood

Installation of the Mount

1. Locate vertical timber stud in your wall to attach ‘TheMount’
2. Drill top hole with a 6mm drill bit. Drill 40mm into timber stud at the recommended height
3. To ensure ‘TheMount’ is LEVEL:
4. Temporarily screw one screw into the top hole
5. Mark the bottom hole while the ‘TheMount’ is level
6. Unscrew the top screw from the wall
7. Drill the marked bottom hole and insert plastic raw plug
8. Screw ‘TheMount’ tightly to the wall using both screws

*If into concrete or brick use a concrete or masonry drill bit
Insert plastic raw plug right into the hole.

NOTE: If installing ‘TheMount’ on the right hand side of a wall, it must be at least a board’s width from the corner, which also applies to any protruding right hand side objects.